![what photoshop do i use with brother gt 541 what photoshop do i use with brother gt 541](https://res.cloudinary.com/gjs/image/upload/t_lightbox,f_auto,q_auto/product/3948-t-lock-platens-for-brother-dtg-printer1.jpg)
In addition, the size of the bill on caps can vary as well. However, some low profile caps may require the printable area to be smaller. So the Large Riser provides approximately 3 inches of printable area. The standard visible area of cap when being worn is approximately 3" in height. So placing your artwork in at the top center of a 14" x 16" platen will help with the placement of the artwork. We designed the GT Cap Platen so that the front of the riser being used would start 5 inches from the center of a 14" x 16" template (standard Adult Platen size) and the top of the Large Riser is at the top of the 14" x 16" template. Working with Artwork for Printing on GT Cap Platen. The springs under the bill holders make it easy to remove the bill from under them. Once the sweatband is under the front lip of the riser, left up and remove the printed cap. Slide the front of the bill forward under the spring loaded bill holders.ģ. Remove the black clips that are holding the crown of the cap flat across the riser.Ģ. Once the cap is printed, you can follow these instructions to remove it from the platen and cure it.
![what photoshop do i use with brother gt 541 what photoshop do i use with brother gt 541](https://www.helpowl.com/manualimages/e/5/brother-international-gt541-instruction-manual-english-b64b5c2_9_54ed.png)
#What photoshop do i use with brother gt 541 how to
How to Remove a Printed Cap from the GT Cap Platen. Use the black clips to lay the crown of the cap as flat as possible across the riser. Pull the crown of the cap back to the riser till the sweat band catches under the lip of the riser.Ĥ. Slide the front of the bill under the spring loaded bill holders.ģ. Flip down the sweat band on the inside of the cap.Ģ. Below are the steps for loading a cap on the GT Cap Platen. One of the core principals we had from the beginning was to make it as easy as possible to get a curved crown as flat as possible to print on.